VXSCAN EL-50588 GM CHEVROLET TPMS Relearn Tool for GM from 2010 to 2017 Year
VXSCAN EL-50588 GM CHEVROLET TPMS Relearn Tool for GM from 2010 to 2017 Year
Note:
EL-50588 GM CHEVROLET TPMS Relearn Tool works for vehicle after 2010 year till some vehicle latest to 2017 year,
some may not till 2017, most can works until 2016 year. Please attention it can not used on Trucks.
Before tire pressure monitoring system works normally properly, the body control module will record ID information of each position
in the tire pressure sensor; and use the following methods to read the tire pressure sensor after replacing a tire or wheel speed sensor.
The package does not include the charger and battery
How to use the el-50588 Gm relearn tool?
Step 1 - Enter leaning mode
Set the gearshift lever to "P"
Put the ignition switch to “ON”
Enter the interface of tire pressure display by DIC
DIC shows "Press Set / Ctrl to re-learn"
Press “Set / Ctrl”
The turn signal is lighted for 3 seconds and the horn beep sound twice to enter the learning mode
Step 2 - Read tire pressure sensor information
Start from the front-left wheel,
Diagnostic Tool EL-50588 antenna up against the valve core position & close to the rim of the tire sidewall
El-50588 tire pressure tool starts by the start switch Successful to read the tire pressure sensor information when the horn bleeps once
Step 3 - Same method to read other tire pressure information
Follow the instuction above to read tire pussure of the front-right, rear-right, rear-left wheels.
Turn signals is lighted for 3 seconds and the horn bleeps twice when the learning is complete.
